Thickness: 5mm~30mm
Width: 1000mm~2500mm or as customer request
Length: 6000mm~12000mm or as customer request
Grade: 30MnCrNiMo
Shanghai Metal Corporation is a professional manufacturer and supplier of 30MnCrNiMo High Strength Steel Plate with high quality and reasonable price.
The high strength steel plate is a high-strength, high toughness steel with excellent mechanical and heat treatment properties and also has good weld ability and process ability, suitable for various processing techniques. The high strength commonly used in lifting, towing, cable ways, ships, and other fields.
If you want to know more about 30MnCrNiMo High Strength Steel Plate price please feel free to contact us, we will reply you within 24 hours
Technical Information of 30MnCrNiMo High Strength Steel Plate:
Grade |
chemical composition |
||||||||
%C |
%Si |
%Mn |
%P |
%S |
%Cr |
%Cu |
%Mo |
%Ni |
|
30MnCrNiMo |
0.26~0.31 |
0.2~0.4 |
0.75~1.10 |
≤0.015 |
≤0.010 |
0.75~1.10 |
≤0.25 |
0.25~0.45 |
1.05~1.30 |
Grade |
Mechanical property |
||
Yield strength/min |
Tensile strength |
Elongation. %min |
|
30MnCrNiMo |
≥785MPA |
≥980MPA |
10 |
Packaging of 30MnCrNiMo High Strength Steel Plate:
Products of Shanghai Metal Corporation are packed and labeled according to the regulations and customer's requests. Great care is taken to avoid any damage which might be caused during storage or transportation. In addition, clear labels are tagged on the outside of the packages for easy identification of the product I. D. and quality information.
1)SMC Standard
2)Customization
Notes:
1.The correct construction posture: For the situation where the plate is installed first and then rusted, when carrying out vertical rust treatment, the following construction posture should be adopted: gradually reduce the direct spraying dose from the top to the bottom (the rust promoting agent flowing from above rusts), otherwise the top is prone to rust and the bottom is prone to excessive corrosion.
2.The order of installation and rusting: usually for better overall effect, it is recommended to install the bulletproof steel plate before rusting treatment. To avoid contamination (such as oil stains, fingerprints, etc.) or scratches on the rust layer during transportation and installation; Secondly, installation usually uses welding and other methods, which not only damages the original rust layer, but also leaves no rust layer covering the weld area, making it look very inconsistent
3.Construction temperature: If the surface temperature of the bulletproof steel plate is too low (below 5 degrees) or too high (over 35 degrees), and the high temperature is exposed to sunlight, it will have a negative impact on the rust formation effect, especially for the application of rust fixing agents. Construction should be avoided under these conditions.